What is the cause of oil leakage in potassium sulfate production equipment?

- Dec 22, 2018-

With the further development of modern chemical industry, we should fully consider its health when using potassium sulfate production equipment, so as to make our production more smoothly. If there is oil leakage in equipment, we also need to make a reasonable analysis, then what is the general cause?


What is the cause of oil leakage in potassium sulfate production equipment?


1. When installing sealing rings in potassium sulphate production equipment, the shaft should be smooth, so as to reduce friction and prevent premature failure of sealing rings.


2. What's more, we should check the flow rate of the hydraulic system of potassium sulphate production equipment reasonably and plan our production mode reasonably so as to make our production more smoothly.


3. In the production of potassium sulfate, we should prevent working too long. If the quality of the sealing ring is poor, it will not be able to resist high temperature.


4. Full consideration should be given to the bearing pressure of the equipment, timely inspection of the pressure of the equipment, to prevent the reduction of overload, resulting in oil leakage at the end of the bearing seat.


The production equipment of potassium sulfate should be inspected reasonably, and enough attention should be paid to inspections. Only in this way can we find problems in the process of using and make relevant adjustments in time.


Add: 9 Qingchun Road, hangzhou, Zhejiang, China

Contact: Yi Fei

Tel: +86-571-87228886

Mob: +8613600538853

Fax: +86-571-87242887

E-mail: asiachem@yatai.cn